Main feature of New Taku-Die

1
Small size and light
Smallest and most light weight in the world. Easy transportation and possible into Glove Box.Due to small size of Die, it allows revise Die design to fit for solusions with low cost.
2
Coating width 2mm-300mm
We have much technical knowlege for narrow coating width.
3
Wide range of coating thickness
Min.Wet1μ-Max.1.5mm
4
Wide range of vicicosity
0.7cps - 150,000cps
5
Very little using solution amount
Only 5cc amount of solution can be coated,and get coating sample. Saving big cost of expensive solution.
6
2-Layer,3-Layer coating possible
Possible to make 2,3 layers slit in 1-Die
7
Wet on Wet coating　
Possible to install 2 coating stations on coater
8
Floating coating
Possible to coat on floating material fixed flame
9
Roll to Roll Coater
Small, light weight and simple coater on table installation
10
Impregnation coating
Semi and Full Impregnation and Both side coating
11
Stripe coating
Coating width Min.2mm
12
Any amount of solution possible
Plunger can push out inside of air in Die autematically in any levell of solution inside of Die.
13
Easy assemble and disassemble Die
Die is composed 3 pieces, and joined by several pieces of bolts. It takes you only 15min for changing solution.
14
Many Die shape design
We have over 10 designs of Die-Shape depend on solution.
15
Cartridge heater Die with thermo controller (Option)
Maｘ..200℃
16
Protection Cover for Die Lip
Cover keeps drying up of Die lip after coating
17
Autematical washing system of Die lip after coating（Option）
This is usefull in Glove Box
18
Intermittently solution supply system （Option）
Solution Tank and pipe and manual Valve are connected　with Plunger. After using out of solution inside of Die,new solution come into Die by Plunger up.
19
Possible to install camera from operation side,(Option）
Possible take picture to invesigate shape of meniscas at coating
20
Die Unit Go up and Down by Motor
Gap controll by motor make decrease swelling solution at position of coating end.
21
Suction Table
Material is Carbon with very small holes 5μ.No suction mark on any material.
22
 Precision Die Slit

Slit width accuracy ±1μ-±1.5μ

Please refer our Brog indetails.